Hold the timing gear with a strap wrench while you tighten the nut.
Take the nuts an washer off first... Then slide the completed gear housing into place. Showing here how far out the bolts will stick out .
These are the three holes in the clutch housing that mate up with the bolts in the gear housing.
For now just set the timing belt in place.
Hold the timing gear with a strap wrench while you tighten the nut.
Install the timing gear pulley on to the pinion gear shaft with the nut as shown. See next picture on how to tighten.
Install the timing gear pulley on to the pinion gear shaft.
Install the gear cover. I changed the screws to socket cap screws.
expressline99

Hold the timing gear with a strap wrench while you tighten the nut.

Media information

Album
Bridgeport Series 1 VS 2hp Rebuilding the Gear Housing
Added by
expressline99
Date added
View count
824
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/23 second(s)
ISO
400
Flash
Off, did not fire
Filename
DSCN5488.JPG
File size
2.2 MB
Date taken
Tue, 11 April 2017 7:04 PM
Dimensions
3648px x 2736px

Share this media

Back
Top