Last thing on the list is installing the R8 collet alignment screw. It's a double set screw as shown.
Last thing to do is slide a collet in and out of the spindle to insure it doesn't bind up. Then install the hollow locking set screw to lock it.
Install the 1st set screw. Normally at this point you put in a R8 collet to insure you don't go to deep with the set screw. I didn't have one handy.
Last thing on the list is installing the R8 collet alignment screw. It's a double set screw as shown.
Bend the tab into place with a screw driver and the mallet.
When you finish tightening the spindle lock nut stop where you can line up one of the tabs with a slot on the nut.
Get the spanner wrench! Tighten the nut down a couple of light taps with the dead blow. Don't over tighten or you will bind the bearings.
Mount the spindle in the vise (with soft jaws or covered in brass like mine.) Bearings on the right side this time.
expressline99

Last thing on the list is installing the R8 collet alignment screw. It's a double set screw as shown.

Media information

Album
Bridgeport Series 1 VS 2hp Spindle rebuild & tear down
Added by
expressline99
Date added
View count
986
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/40 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5255.JPG
File size
2.2 MB
Date taken
Thu, 30 March 2017 8:16 PM
Dimensions
3648px x 2736px

Share this media

Back
Top