Showing Mounting Holes For Spindle Pulley Hub
The dowel pin for the handle.
There is where the set screw holds the pin in place...this faces out. Seems obvious but anyway. :)
Spindle brake handle with pin and set screw.
Showing Mounting Holes For Spindle Pulley Hub
Now put the new drive belt on. Secure it with a zip tie to keep it on and out of the way.
Lower view of the top spindle pulley hub bearing sitting directly on the snap ring.
A new bearing (6007 double sealed) should be installed on top of the spindle pulley hub. After installed.
expressline99

Showing Mounting Holes For Spindle Pulley Hub

This is the bottom view of the lower belt housing the two holes lower right and upper left are the mounting holes. Two cap head screws secure the spindle pulley hub through these into the brake bearing cap.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
758
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/51 second(s)
ISO
200
Flash
On, fired
Filename
DSCN5435(b) edited showing mounting holes for spindle pulley hub.JPG
File size
230.6 KB
Date taken
Sun, 09 April 2017 3:14 PM
Dimensions
1238px x 929px

Share this media

Back
Top