The variable disk must be set in place inside the belt housing before installing the motor.
view of the motor shaft installed through the variable disk assembly Held in place with a snap ring.
At this point you have to wrestle the motor on and line up the keyway on the variable disk as you lower the motor in.
Bottom view of the variable disk with the spring still compressed via the long screws I installed.
The variable disk must be set in place inside the belt housing before installing the motor.
View of the installed fixed motor pulley.
The rear of the fixed motor pulley has a set screw that must be tightened. This keeps the pulley in place along with the pinned key.
This is the key for the fixed motor pulley. It's tapered and has a pin for the pictured "pin hole" that keeps in in place on the shaft.
expressline99

The variable disk must be set in place inside the belt housing before installing the motor.

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
920
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
400
Flash
Auto, fired
Filename
DSCN5873.JPG
File size
2.2 MB
Date taken
Sun, 11 June 2017 3:02 PM
Dimensions
3648px x 2736px

Share this media

Back
Top