Tighten the 3 cap screws down and you've installed the bearing cap. Next!
After the two screws are installed that hold the speed change assembly on the belt housing.
The speed change assembly is held on the belt housing by two socket head screws that go here.
The spindle speed change plate. The long screws hold the speed change assembly on to the belt housing. The little screws hold the face plate on.
Tighten the 3 cap screws down and you've installed the bearing cap. Next!
Another view of where you install the bearing cap screws.
Install the 3 cap head scres like so. The other three holes in the cap are used for removing a stuck cap.
I had put witness marks when I removed the bearing cap. If you did make sure to line them up.
expressline99

Tighten the 3 cap screws down and you've installed the bearing cap. Next!

Media information

Album
Bridgeport Series 1 VS 2hp reinstalling lower/upper belt housing on the head
Added by
expressline99
Date added
View count
724
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/49 second(s)
ISO
193
Flash
Auto, did not fire
Filename
DSCN5754.JPG
File size
2.1 MB
Date taken
Sat, 20 May 2017 7:56 PM
Dimensions
3648px x 2736px

Share this media

Back
Top