- Joined
- Mar 25, 2013
- Messages
- 4,613
Does any one out there use a DC motor controller you are happy with? If so what is the make and model?
I am asking because I am not entirely happy with the KB controller I used for my South Bend lathe project.
http://www.hobby-machinist.com/threads/the-new-south-bend-10k.30542/
It would need it to be reversible and be rated up to 1 HP. I have not seen much discussion on controllers so I think it would be helpful.
Robert
I am asking because I am not entirely happy with the KB controller I used for my South Bend lathe project.
http://www.hobby-machinist.com/threads/the-new-south-bend-10k.30542/
It would need it to be reversible and be rated up to 1 HP. I have not seen much discussion on controllers so I think it would be helpful.
Robert
Last edited: