Walter Shu Iv Dividing Head

Lornie McCullough

H-M Supporter - Gold Member
H-M Supporter Gold Member
Joined
Feb 13, 2014
Messages
43
I recently acquired this dividing head (rotary table?) without any dividing plates or instruction manual. It appears to be a wonderful piece of equipment.....

Can you help me find an instruction manual/parts list for it. Thank you.

Lornie
 
Thank you royesses........I believe there should be a means of making the head freewheel, and perhaps also a way of adjusting the head-locking lever. Right now the head-locking lever bumps into the dividing plate area..... I'm a bit confused about how to use this piece of equipment.

WalterSHU4.jpg
 
Thank you again royesses...... I got a reply and an exploded diagram from the walter-praeziaion.de link. It is a great help!

Lornie
 
I recently got a Walter HU-80 dividing head as part of a mill purchase. Just wanted to say thanks for sharing this lead; I just emailed them to see if I could get a copy of the manual.
 
I recently got a Walter HU-80 dividing head as part of a mill purchase. Just wanted to say thanks for sharing this lead; I just emailed them to see if I could get a copy of the manual.

If you get one, is that something you attached here or put in our downloads location?
That could help others.

-brino
 
@Lornie - what is the model of that dividing head?

These popped up on eBay (link) - they look like they would be for a Walter SHU IV (aka SHU 4). They are a slight bit smaller than what is used on the Walter SH-80, but otherwise look identical in other respects.

The hole pattern matches the info on this Walter brochure: link
 
Back
Top