- Joined
- Sep 26, 2013
- Messages
- 408
See the pics for reference. The chuck backing plate has a broken thread at the thread start, I can get it to thread on but it tightens after about 1 1/2 revolutions at which point I stop. Thread is 2 1/4 x 8.I am thinking about using a dremel and removing the jagged broken edge and see how that goes. Any suggestions on how to repair this?
I don't have access to a tap, but that may be what I need to clean it up. Again, the only part of the thread damaged is at the start.
thanks, Brian
I don't have access to a tap, but that may be what I need to clean it up. Again, the only part of the thread damaged is at the start.
thanks, Brian
Last edited: