NEW OLD HEAVY 10 + TOOLING +

When I dissembled head stock for cleaning I noticed the bearing caps were snug not tight and the expanders were not tight eather , don't know if it was getting warm then ,I didn't run it long it was a mess.
I'm thinking 10 - 12 ft lbs on caps and 4-5 in lbs on ex panders after checking shims flushing .
Derrick
 
dlane said:
Got a knockout nut and reverse tumbler stud screw from plaza mach $60 both were junk. knockout nut has a blown out hole and stud screw slipped rite in no pressing sloppy fit. Any one know of a good source for heavy 10 parts.
Thanks
Derrick
Click to expand...

I'm sure joe at Plaza machine will take it back and provide a full refund. he is a very reputable source and probably your best choice....give him a call or e-mail back.
 
Thanks joe , me and joe at plaza are squared up, thanks for reminding me about plaza , I'm now looking for old atlas/craftsman Dp parts I'll give him a try.
 
You must log in or register to reply here.
Back
Top