Renegade Prints (build Has Begun)

Yup, I need the aux. table only because of the 10 inch width and it needs to be angled to get the straight cut. Flip it over and do the other side. I ordered a new indexable face/side cutting shell mill 2.5 diameter 6 inserts.

"Billy G"
 
I'd like to watch as Mark just sets it up. You would have to set it on edge and angle one end up. That translates to the first corner to be cut is over 12 inches in the air. No throat room I'm afraid. Plus at 65 lbs. that piece would be extremely difficult to handle standing only on it's 1.5 inch edge.

"Billy G"
 
Last edited by a moderator:
Aux. Table (Engineering Plate) is bolted down now and the new table measures .500X10X24. Almost ready to go. Just need a sacrificial piece to go betweed the work and table.

"Billy G"

102_1127 (700 x 465).jpg
 
The white template is the full size of the base. It dwarfs the table. The template ios to help figuring out whae This is gonna be fun.

"Billy G"
102_1128 (700 x 465).jpg
 
I would love to get a copy of the prints.
for a long time I have been interested in making a rail gun put don't know how or where to begin.
Good luck making it.
 
I was only gone from the shop for a couple of hours. I get back and the table is now 15X33. I will get the piece cut to 10X27 and we will be ready to go.

"Billy G"

102_1130 (700 x 465).jpg
 
Metal meats metal for the first time. All is in position. but not installed. Had to have a peek. LOL

"Billy G"

102_1131 (700 x 465).jpg 102_1132 (700 x 465).jpg
 
Last edited by a moderator:
Very nice Bill! Really looking forward to seeing this thing when it's done. They'll be drooling all over it at the range. :)
 
One or two more days cleaning and re-arranging and it's back to work. I put this off way too long. LOL I found three machines that need to be rebuilt.

"Billy G"
 
Back
Top