Wells Index converted my Van Norman 16 mill spindle with the VN "C" taper; to an R8 taper. It cost a lot more than $200. But at least now I can get a whole new world of tooling--I'll be selling the VN C tooling I've acquired.
I may be in a minority with a Van Norman mill with a Bridgeport taper-
I just got the spindle head back today and will put it on the mill tomorrow and check the runout--it better be good!!
Thanks to everyone for all the help-- I'm sure I'll be back with more questions!!
Bob
I may be in a minority with a Van Norman mill with a Bridgeport taper-
I just got the spindle head back today and will put it on the mill tomorrow and check the runout--it better be good!!
Thanks to everyone for all the help-- I'm sure I'll be back with more questions!!
Bob