- Joined
- Jul 29, 2011
- Messages
- 6
marilyn blood
show details Jul 31 (4 days ago)
Here is a photo of my refurbished South Bend G-26-T 13 X 36 lathe. I did not have the same challenge you did with corrosion. My challenge was a major clean-up job inside and out. They must have blown the chips off the lathe for years using an air hose which forced small chips in places I didn't believe were possible. I replaced the OEM Baldor 3-phase motor with a single phase 2 hp. Marathon motor made right here in Wisconsin. Mike at SB parts department told me that some of the Taiwanese parts will be available in the future. I sure hope so.
I am new at this type of forum. If the photos don't come thru, please let me know. Thanks.
Dave
show details Jul 31 (4 days ago)
Here is a photo of my refurbished South Bend G-26-T 13 X 36 lathe. I did not have the same challenge you did with corrosion. My challenge was a major clean-up job inside and out. They must have blown the chips off the lathe for years using an air hose which forced small chips in places I didn't believe were possible. I replaced the OEM Baldor 3-phase motor with a single phase 2 hp. Marathon motor made right here in Wisconsin. Mike at SB parts department told me that some of the Taiwanese parts will be available in the future. I sure hope so.
I am new at this type of forum. If the photos don't come thru, please let me know. Thanks.
Dave
Attachments
Last edited by a moderator: