Hitachi Wj200 Error Message

Fltenwheeler

Registered

Registered

Joined

Jun 29, 2016

Messages

16

• Aug 30, 2016

• #1

Hi

I am using a Hitachi WJ200-015SF as a phase converter to run a Rockwell 14x30 lathe.

I have the out put of the VFD set to 60Hz and am using the speed control that is built into the lathe. When I slow the lathe down from the upper speeds I get an E07.3 error code. Over voltage protection on the DC bus voltage. Is there any way to stop this from happening?

Thanks

Tim

 

JimDawson

Global Moderator

Staff member

H-M Lifetime Diamond Member

Joined

Feb 8, 2014

Messages

11,144

• Aug 30, 2016

• #2

Yup, add a braking resistor, or increase the decel time.

 

Fltenwheeler

Registered

Registered

Joined

Jun 29, 2016

Messages

16

• Aug 30, 2016

• #3

Ok

Would a 50ohm 300 watt resistor work?

Thanks

Tim

 

JimDawson

Global Moderator

Staff member

H-M Lifetime Diamond Member

Joined

Feb 8, 2014

Messages

11,144

• Aug 30, 2016

• #4

A quick internet search indicates that a 50 ohm is the correct value. 300 watts should be OK.