All Electric Power Drawbar

Thanks everyone for the replies.

After much digging and researching, while my gear motor idea is doable, the electronics necessary to make it work get out of my comfort zone and the effort required is not worth the time and $$$ for this particular machine.

I was able to locally see a system using the guts from a 1/4" cordless impact driver that works very well with plenty of torque for an R8 collet. Actually faster and no where near as obnoxious as the air impact system I originally had on my other mill.

I would rather not deal with batteries for a cordless system so I found a 110vac corded impact driver. If I find it has the required torque then I will modify it for a permanent setup.
 
Back
Top