so, i just acquired a mill and a lathe off of ebay for $9 from a fellow whose house was flooded in Long Island during Sandy.
mill is an rf-45 clone, a zay7045fg/2 is the exact model number...?
according to the seller, it was purchased directly from the factory, and is unbranded.
surprisingly large, i bet it weighs more than my rockwell 21-100 knee mill.
i am assuming most of the electricals on both are no good...
lathe is a cz1224g. 12 x 24, gap bed, geared head.
seems decent enough from what i have seen so far.
might just sell the mill along / fix it up a bit as i dont really need it.
the lathe i was hoping to use. it will need a new motor. the rest of it actually doesnt
look too bad. it was on a 3 foot base, so i dont think the lathe got flooded with sea water at all,
but it was left in the rain a while after the hurricane.
wondering if anyone can help find a replacement motor.
heres the motor details.
the present motor is 220, would prefer 110 if possible.
bolt spacing: approx 4.8 in x 5.4 in
shaft dimensions: .949 in shaft x 2 inches long (seems like weird shaft size, close to 24 mm?)
model number: yl-9024 motor
1100 w 220v 7 amps
double capacitor single phase (run and start capacitor)
and some photos: