Atlas M1-570 End Mill Driver

brandon428

H-M Supporter - Silver Member
H-M Supporter - Silver Member
Joined
Nov 15, 2020
Messages
138
Anyone have one of these for the Atlas Milling Machines they're willing to part with?
 
the headstock is MT2
MT2 Collets will work, you'll need to make a drawbar from 3/8"x16tpi all thread
 
Yeah, was hoping to find an original part. Most people just use the MT2's nowadays? :)

Curious though, why would the drawbar need to be all thread?
 
Not original equipment but one can find #2 Morse taper end mill holders if you want to go that route instead of collets. That’s what I use on my MF, found them at All Industrial Supply I think. The original Atlas parts may be hard to come by, I don’t think I’ve ever run across one listed.

-frank
 
Yeah, was hoping to find an original part. Most people just use the MT2's nowadays? :)

Curious though, why would the drawbar need to be all thread?
it doesn't need to be all-thread, just a simple solution - otherwise a long bolt would suffice
 
Back
Top