- Joined
- Jan 23, 2013
- Messages
- 107
I have recently installed a 2 HP 3 phase motor on my lathe along with a 2 HP TECO VFD from automation direct.
The lathe slows down under all but the lightest cuts.
for example at 46 hz took a light facing cut lathe slowed to a crawl.
Is this a normal result of not running it a 60 HZ? It does the same thing at 60hz just not as bad.
The lathe slows down under all but the lightest cuts.
for example at 46 hz took a light facing cut lathe slowed to a crawl.
Is this a normal result of not running it a 60 HZ? It does the same thing at 60hz just not as bad.