A view of how the rail looked attached to the ledge on the pallet.
A close up of the factory installed mount pads. Had to make sure these didn't get pryed off while sliding it down the rail.
There are mounting pads on the bottom of the plate. These had to fit between the rails. I had to keep adjusting as I slid it.
Another view of the rails on the stand. The mounting screws are turned down below the level of the sideways 2x4s
A view of how the rail looked attached to the ledge on the pallet.
I placed a single support under the center. I made sure that the 2x4s were directly supporting the load.
I made sure the rails were as wide as the stand. Which I made an inch wider than the plate for room to move. So it needed a couple of 25" spacers.
There was a slight slope from the truck to the stand. Roughly 6" of drop. These are the rails I attached to the ledge I put on the stand.
expressline99

A view of how the rail looked attached to the ledge on the pallet.

Media information

Album
Moving the surface plate from the van to the stand
Added by
expressline99
Date added
View count
766
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/170 second(s)
ISO
64
Flash
On, fired
Filename
DSCN5938.JPG
File size
2.1 MB
Date taken
Sat, 15 July 2017 3:14 PM
Dimensions
3648px x 2736px

Share this media

Back
Top