After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier
The long screws that hold the motor top plate on.
Pull the wires through the motor top and install it using the 4 long screws. Do this before putting the motor casing back on.
You can now slide on the motor casing lining up the wires and pulling them through as shown.
After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier
Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
New bearings pressed on to the rotor ready to go!
New bearings in hand and everything cleaned up. Install'em. Press them on using only the inner race. A 6203 and a 6206.
expressline99

After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier

This is where those marks you placed on the base and top come into play. Line it all up the way it came off.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
567
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
400
Flash
Auto, fired
Filename
DSCN5852.JPG
File size
2.2 MB
Date taken
Thu, 08 June 2017 6:13 PM
Dimensions
3648px x 2736px

Share this media

Back
Top