All 4 bolts in roughly lined up position.
Once you have the head in place the bolts should stick out about this much.
The head is in place! Time to put the washers and nuts on the bolts.
My table was tilted and the ram was adjusted to match the tilt. So have a 3/4" wrench ready to make adjustments.
All 4 bolts in roughly lined up position.
This is how the bolts slide around the slot....basic but how they go.
There is a notch in the ram as shown. The bolts go in this way and are tilted up into position. Then slide them around to approximate location..
The bolts, washers and nuts needed to install the head. These have square heads.
expressline99

All 4 bolts in roughly lined up position.

Media information

Album
Bridgeport Series 1 VS 2 HP reinstall head
Added by
expressline99
Date added
View count
746
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
400
Flash
On, fired
Filename
DSCN5978.JPG
File size
2.1 MB
Date taken
Sat, 29 July 2017 6:06 PM
Dimensions
3648px x 2736px

Share this media

Back
Top