At this point you can remove the feed screw if you have removed the handle/power feed on the right side of the unit.
Believe it or not this is where the table gib adjustment screw is... take it out.
The bearing numbers for this feed screw.
Now you need to press out or tap out your bearings for replacement.
At this point you can remove the feed screw if you have removed the handle/power feed on the right side of the unit.
The end of the feed screw.
Another view of the feed screw.
A view of the bearing bracket (with bearings still installed there are 2)
expressline99

At this point you can remove the feed screw if you have removed the handle/power feed on the right side of the unit.

Reinstall the handle to crank it out. My woodruff key was so hard to remove on this I used a towel and a set of vice grips to turn it out. Spin until it comes free.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Tear down of the table and saddle
Added by
expressline99
Date added
View count
509
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/63 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN6010.JPG
File size
2.2 MB
Date taken
Sun, 06 August 2017 4:44 PM
Dimensions
3648px x 2736px

Share this media

Back
Top