Brake bearing cap. This is just to show those two screws that hold the brake bearing cap to the lower belt housing.
Lower view of the top spindle pulley hub bearing sitting directly on the snap ring.
A new bearing (6007 double sealed) should be installed on top of the spindle pulley hub. After installed.
A new bearing (6007 double sealed) should be installed on top of the spindle pulley hub.
Brake bearing cap. This is just to show those two screws that hold the brake bearing cap to the lower belt housing.
View two after installing the spindle pulley hub assembly.
View one after installing the spindle pulley hub assembly.
There is a flat on the brake bearing cap (I messed up the picture it was on the other side)
expressline99

Brake bearing cap. This is just to show those two screws that hold the brake bearing cap to the lower belt housing.

I had missed this part of the pictures on the reassembly. Not sure how that happened.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp belt housing tear down and rebuild
Added by
expressline99
Date added
View count
759
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
400
Flash
Auto, fired
Filename
DSCN5532.JPG
File size
2.2 MB
Date taken
Fri, 14 April 2017 7:17 PM
Dimensions
3648px x 2736px

Share this media

Back
Top