Front view after the gear housing is installed on top of the quill housing.
Side view after the gear housing is installed on top of the quill housing. Your gear housing is done!
Front view after the gear housing is installed on top of the quill housing.
The third bolt on the back that will need the washers and nut.
Take the nuts an washer off first... Then slide the completed gear housing into place. Showing here how far out the bolts will stick out .
These are the three holes in the clutch housing that mate up with the bolts in the gear housing.
For now just set the timing belt in place.
Hold the timing gear with a strap wrench while you tighten the nut.
expressline99

Front view after the gear housing is installed on top of the quill housing.

Media information

Album
Bridgeport Series 1 VS 2hp Rebuilding the Gear Housing
Added by
expressline99
Date added
View count
919
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/33 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5503.JPG
File size
2.2 MB
Date taken
Thu, 13 April 2017 6:35 PM
Dimensions
3648px x 2736px

Share this media

Back
Top