Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
Pull the wires through the motor top and install it using the 4 long screws. Do this before putting the motor casing back on.
You can now slide on the motor casing lining up the wires and pulling them through as shown.
After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier
Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
New bearings pressed on to the rotor ready to go!
New bearings in hand and everything cleaned up. Install'em. Press them on using only the inner race. A 6203 and a 6206.
The old bearing from the output end. Remember the smaller end is a 6203 and this is a 6206 double SEALED not shielded!
expressline99

Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.

Not sure where my picture of this washer has gone. But it's a washer that gives the bearing a little space between it and the motor base.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
523
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/30 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5851.JPG
File size
2.3 MB
Date taken
Tue, 06 June 2017 8:59 PM
Dimensions
3648px x 2736px

Share this media

Back
Top