New bearings pressed on to the rotor ready to go!
You can now slide on the motor casing lining up the wires and pulling them through as shown.
After you press the rotor into the motor base. you can carefully slide the stator/windings and casing on. Make sure you line up the marks from earlier
Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
New bearings pressed on to the rotor ready to go!
New bearings in hand and everything cleaned up. Install'em. Press them on using only the inner race. A 6203 and a 6206.
The old bearing from the output end. Remember the smaller end is a 6203 and this is a 6206 double SEALED not shielded!
View after the lower bearing has been removed. See the keyway has a hole in it? The key seats there.
expressline99

New bearings pressed on to the rotor ready to go!

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
463
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Filename
DSCN5850.JPG
File size
43.6 KB
Dimensions
600px x 450px

Share this media

Back
Top