Slide the worm gear on to the shaft. Line up the drilled holes in the shaft with the ones on the gear. :)
The speed change hub on mine seemed tight. I removed it and cleaned it up nicely. I pressed it out. Put the nut on first so you can press on it.
Worm gear after the roll pin has been installed.
Install the roll pin to hold the gear on to the shaft.
Slide the worm gear on to the shaft. Line up the drilled holes in the shaft with the ones on the gear. :)
Start rebuild. After everything is cleaned up. Lightly oil the speed change shaft before inserting into the housing.
Speed change hub still installed in the bearing block...angled view.
Speed change hub cleaned up...still in bearing block.
expressline99

Slide the worm gear on to the shaft. Line up the drilled holes in the shaft with the ones on the gear. :)

You'll notice this shaft is different than the first pictures of it... this is the one I had to make.
Click to expand...

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
826
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/39 second(s)
ISO
400
Flash
Auto, did not fire
Filename
DSCN5688.JPG
File size
2.2 MB
Date taken
Fri, 19 May 2017 4:04 PM
Dimensions
3648px x 2736px

Share this media

Back
Top