Start rebuild. After everything is cleaned up. Lightly oil the speed change shaft before inserting into the housing.
Worm gear after the roll pin has been installed.
Install the roll pin to hold the gear on to the shaft.
Slide the worm gear on to the shaft. Line up the drilled holes in the shaft with the ones on the gear. :)
Start rebuild. After everything is cleaned up. Lightly oil the speed change shaft before inserting into the housing.
Speed change hub still installed in the bearing block...angled view.
Speed change hub cleaned up...still in bearing block.
Speed change hub showing the chain attached with a roll pin
expressline99

Start rebuild. After everything is cleaned up. Lightly oil the speed change shaft before inserting into the housing.

Media information

Album
Bridgeport Series 1 VS 2hp Upper belt housing tear down and rebuild
Added by
expressline99
Date added
View count
571
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5686.JPG
File size
2.1 MB
Date taken
Wed, 10 May 2017 5:38 PM
Dimensions
3648px x 2736px

Share this media

Back
Top