The old bearing from the output end. Remember the smaller end is a 6203 and this is a 6206 double SEALED not shielded!
Motor base. Time to install the rotor and stator/casing. There is a spring washer that goes in here before you press the rotor in.
New bearings pressed on to the rotor ready to go!
New bearings in hand and everything cleaned up. Install'em. Press them on using only the inner race. A 6203 and a 6206.
The old bearing from the output end. Remember the smaller end is a 6203 and this is a 6206 double SEALED not shielded!
View after the lower bearing has been removed. See the keyway has a hole in it? The key seats there.
Time to press out the "output" end of the shaft bearing. Like my 2x4? Protect the shaft!
View of the rotor shaft after the top bearing is removed. This end gets the fan!
expressline99

The old bearing from the output end. Remember the smaller end is a 6203 and this is a 6206 double SEALED not shielded!

Media information

Album
Bridgeport Series 1 VS 2hp Motor Tear Down and Bearing replacement
Added by
expressline99
Date added
View count
443
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/5.6
Focal length
6.3 mm
Exposure time
1/60 second(s)
ISO
200
Flash
Auto, fired
Filename
DSCN5805.JPG
File size
2.2 MB
Date taken
Fri, 26 May 2017 8:02 PM
Dimensions
3648px x 2736px

Share this media

Back
Top