Tighten the key into place on the motor pulley vari-disc with the cap screw. The key on the spindle pulley goes into place by just clicking it in.
Tighten the key into place on the motor pulley vari-disc with the cap screw. The key on the spindle pulley goes into place by just clicking it in.
Install the key into the motor pulley.
I had to hurry to get the sleeve in so couldn't take a picture. you need to coat the sleeve with wd-40 or some light oil.
Over lap the bushing like this and hold it with a pair of needle nose pliers while you insert it. Lip towards the center of the pulley.
Put half of the glue in the top all the way around. (Half in the bottom)Don't need it in the key way. Not needed in the center recess either.
Mix up the glue for one pulley at a time. Mix until it's a uniform color. You only have 3-5 minutes of working time on the glue! So hurry!
Going to need a pair of needle nose to hold the bushing during install.
expressline99

Tighten the key into place on the motor pulley vari-disc with the cap screw. The key on the spindle pulley goes into place by just clicking it in.

Media information

Album
Bridgeport Series 1 2hp variable speed, bushings being redone.
Added by
expressline99
Date added
View count
885
Comment count
0
Rating
0.00 star(s) 0 ratings

Image metadata

Device
NIKON COOLPIX S560
Aperture
ƒ/3.5
Focal length
6.3 mm
Exposure time
1/14 second(s)
ISO
400
Flash
Off, did not fire
Filename
DSCN5497.JPG
File size
2.2 MB
Date taken
Thu, 13 April 2017 5:59 PM
Dimensions
3648px x 2736px

Share this media

Back
Top