My Rockwell 14 X 40 Lathe

4GSR - did you ever get the nut info you wanted? I can get it off my machine. JJTGrinder


Sent from my iPhone using Tapatalk
 
4GSR - did you ever get the nut info you wanted? I can get it off my machine. JJTGrinder


Sent from my iPhone using Tapatalk

No, I did not. I still like to get the information so when I get to that point, make the nut.
 
Would it be the "pully retainer nut" , number 12 on the parts list?
I will post a photo tomorrow of the parts list page that way you can specify which part.
 
Last edited:
Would it be the "pully retainer nut" , number 12 on the parts list?
I will post a photo tomorrow of the parts list page that way you can specify which part.

Yep, that's it. I have the parts list that I copied from the Rockwell Metalworking Lathe group. But feel free to post if you like for others to see.
Thanks,
Ken
 
Yep, that's it. I have the parts list that I copied from the Rockwell Metalworking Lathe group. But feel free to post if you like for others to see.
Thanks,
Ken

i uploaded a diagram "20151031".
For the serial numbers 133-4208 and higher the nut is a (1 3/4-16) , for the serial numbers lower than 133-4208 the nut is a ( 1 7/8 - 16).
---------------------------------------------------- part ref no 86 -/\ ---------------------------------------------------------------part ref no 800 - /\.
Let me know what your serial number is. And how to proceed.
My serial number is 137-6706. So my nut is probably a 1.75-16.

JJTGrinder
 
Not too worried about the thread, but its nice to know ahead of time. S/N of mine is 1515517, according to the stuff in the Rockwell Lathe group over on Yahoo, it was born in 1970.
Ken

Edit: Thanks for the download. That's a little bit different from that that I have on hand. The headstock configuration I have matches to that in the second page (42). It's item 86 that I need dimensional information on. Just need the OD and the length or thickness of the nut. I can figure out the thread bore.
 
Last edited by a moderator:
Not too worried about the thread, but its nice to know ahead of time. S/N of mine is 1515517, according to the stuff in the Rockwell Lathe group over on Yahoo, it was born in 1970.
Ken

Edit: Thanks for the download. That's a little bit different from that that I have on hand. The headstock configuration I have matches to that in the second page (42). It's item 86 that I need dimensional information on. Just need the OD and the length or thickness of the nut. I can figure out the thread bore.
Get it for you this week.
JJTGRINDER
 
My daughter (and husband, grandkids) came over this weekend. That always changes my shop time. Did not get the info for you, I am going to get it tonight if possible.
no reply expected, John
 
Back
Top