Another Lathe Dro Install

Very nice. Thanks for posting it. You are giving me ideas for a DRO install on my "new to me" lathe.
 
Beautiful job - I too would love to get those SolidWorks files. I am doing a similar build now and would love to look at your solutions in mor detail.
 
Beautiful job - I too would love to get those SolidWorks files. I am doing a similar build now and would love to look at your solutions in mor detail.
The files were posted in the Downloads section about a month ago.
 
The files were posted in the Downloads section about a month ago.

Great - I am new to this forum and hunted about for a "Downloads" section. It is alas eluding me. Could you please point me in the right direction? Your help is much appreciated!!!
 
Great - I am new to this forum and hunted about for a "Downloads" section. It is alas eluding me. Could you please point me in the right direction? Your help is much appreciated!!!
It is the 5th tab in on the upper header strip at the top of the page.
Header Strip.JPG
 
Hmmm, that is not the banner which I see on my iPad and the order is not the same on the existing options. I will look on another device/OS. I found a post from two years that talked about the Download item disappearing. Vexing...
 
Your post count may be too low right now. You have enough posts to have "active member" status or have made a donation to the site to have access to the downloads section.

Get a couple more posts on your count and it should show up in the top banner just after "notifications".

I'm not sure what the total count has to be off the top of my head...
 
What did you use for the conduit? It should be obvious but I'm a little overwhelmed.. Starting this same project on my lathe..
 
RJ
Is this tubing oil tight, i.e. won't let oil get into the wiring, or is this a problem?

CHuck the grumpy old guy
 
Back
Top