- Joined
- Sep 15, 2017
- Messages
- 321
Hi Tony just for your interest i tried some hercus lathe tool steel on the angle grinder disc attached to my belt sander project .well i am very supprised it tears tool steel away in no time flat with not a lot of heat .It does not leave a mirror finish however fine for what im doing .there is basically now wear to the disc either .here is a pic or 2 of a peice of tool steel i roughed out from just a straight end its not a miror finish but ok for what im doing it took about 3 minutes to rough out and not a lot of heat was produced i was holding tbe tool steel by handYou probably will end up dressing it flat if you intend to do any tool sharpening that has straight edges.