King Way Design

The spec on it is 0.001"/10" (0.1 mm/m). Not quite as good as the master precision, but way better than the general machinist level.

Do you have any guides to use of the King Way other than the various contraptions in Connelly?

Thanks,
Will
 
The spec on it is 0.001"/10" (0.1 mm/m). Not quite as good as the master precision, but way better than the general machinist level.

Do you have any guides to use of the King Way other than the various contraptions in Connelly?

Thanks,
Will

Yes, I'd be interested too as I don't remember a vial on the "various contraptions" either. I only remember them being for holding test and dial indicators only.
 
....................Do you have any guides to use of the King Way other than the various contraptions in Connelly?

Thanks,
Will

All I have is the Connelly book. Richard King has posted a copy of the instructions somewhere. I don't think it was here. Maybe he will tune in and say.
 
I read through that once, but I don't recall the examples particularly clearly... I'll try and dig it up to include in my King Way folder on my computer. If anyone else has it handy, I'd appreciate being linked again.

Thanks,
Will
 
Back
Top