X2 Mini Mill CNC Conversion?

I dont have break out board yet but i posted pics a few threads down

Ok the wires on the motors are blue , black , red , green and the sheilded wire colors are black , red , green , white
 
great you got the easy breakout board you can follow the video and wire the board to each driver. leave enough of the shield lead ( bare wire ) on one end to mount to the enclosure to ground. dont worry about the limits and estop at this time
I need to know:
the new shielded wire colors
the motor wire colors
do you have an ohm meter?
steve
 
great you got the easy breakout board you can follow the video and wire the board to each driver. leave enough of the shield lead ( bare wire ) on one end to mount to the enclosure to ground. dont worry about the limits and estop at this time
I need to know:
the new shielded wire colors
the motor wire colors
do you have an ohm meter?
steve

Ok the wires on the motors are blue , black , red , green and the sheilded wire colors are black , red , green , white
I do have an ohm meter but not with me i will have to get it tonight or tomorrow along with the solding gun and heat shrink tube.
 
great you got the easy breakout board you can follow the video and wire the board to each driver. leave enough of the shield lead ( bare wire ) on one end to mount to the enclosure to ground. dont worry about the limits and estop at this time
I need to know:
the new shielded wire colors
the motor wire colors
do you have an ohm meter?
steve


Watching that video does not help me dont know what he means by CP or CW
 
motor wires if the same colors as your motor wiring diagram below for 4 wire motor are :
motor A ( black ) is A+ on controller (black coming out of shielded cable)
motor B (green ) is A- on controller (green " " )
motor C (red ) is B+ on controller (red " " )
motor D (blue) is B- on controller ( white coming out is the blue now )
leave plenty shield wire to ground one end inside enclosure to case
any guestions so far for motor to controller?
steve
 
set each motor drivers switches as follows
1 on
2 on
3 off
4 off
5 off
6 on
7 on
8 on
thats where we will start
i need to know the tpi or thread pitch if metric for your ball screws when you have time no hurry lots to do first.
steve
 
motor wires if the same colors as your motor wiring diagram below for 4 wire motor are :
motor A ( black ) is A+ on controller (black coming out of shielded cable)
motor B (green ) is A- on controller (green " " )
motor C (red ) is B+ on controller (red " " )
motor D (blue) is B- on controller ( white coming out is the blue now )
leave plenty shield wire to ground one end inside enclosure to case
any guestions so far for motor to controller?
steve

A little confused
 
Back
Top