Are there some good alternatives to R8 quick change tooling?
I haven't looked into Tormach TTS much but I came across an Erickson R8-NMTB30 quick change at an auction that sparked an interest in learning more. I find changing collets and then to a drill chuck, changing the table height to get the chuck in place a pain in the arse. I'm not willing to give up any rigidity though.
I see there is an Ultron Snap Change R8 Tool Change System up for auction here this week.
I haven't looked into Tormach TTS much but I came across an Erickson R8-NMTB30 quick change at an auction that sparked an interest in learning more. I find changing collets and then to a drill chuck, changing the table height to get the chuck in place a pain in the arse. I'm not willing to give up any rigidity though.
I see there is an Ultron Snap Change R8 Tool Change System up for auction here this week.
Last edited: