- Joined
- May 9, 2014
- Messages
- 415
Well, you don't have the actual point-of-operation guarded at this point, either.
Well, you don't have the actual point-of-operation guarded at this point, either.
This may be a stretch, but is the screw pattern in the guard a square? If so, could the guard be installed incorrectly on the horizontal as opposed to the vertical orientation?
-frank
Perhaps a small dowel pin pressed into the back of the lexan guard that has a corresponding hole on the stiffener plate so that it could only be installed one way.
Does the wrist pin rub on the guard?