MENTEM 551

It appears to be an electronic measuring setup with a stylus type probe instead of a DTI type probe. Metric and imperial with multiple ranges down to .0003" full scale. If so, and if it works, I want it! I wonder if it would run on 120V AC?
 
I have a surface roughness checker that I will never use, got it in an auction lot with a bunch of other stuff, i should just dig it out and post it for sale.
 
Last edited:
It appears to be an electronic measuring setup with a stylus type probe instead of a DTI type probe. Metric and imperial with multiple ranges down to .0003" full scale. If so, and if it works, I want it! I wonder if it would run on 120V AC?
Its woking Bob

SAM_0111.JPG

SAM_0112.JPG

SAM_0113.JPG
 
Ah, yes. 9V DC. That works. Very nice, Robert! What is the diameter of the sensor barrel? 9mm? 10mm?
 
Ah, yes. 9V DC. That works. Very nice, Robert! What is the diameter of the sensor barrel? 9mm? 10mm?
Bob. Mentem is a CEJoansson Company(of course) On the side 29- 31 you find al info
 

Attachments

  • Exportkatalog2.pdf
    4.2 MB · Views: 6
Is that a surface roughness checker?

Metem 551 and 552 are respectively, analogue and digital measuring instruments, used with indicating hand gauges like bore and shaft gauges or with probes in a measuring stand, etc..
Metem 551 and 552 are designed for dimensional measuring and inspection. The measurements can be made with bore or shaft gauges, or with measuring stands. Metem 551 is an analogue instrument for metric and inch units. The instrument reading is adjustable from ± 10 μm to ± 1000 μm (± .0003" to ± .03"). Metem 552 displays the measuring results digitally, in metric or inch units. The display ranges are ± 20 μm, ± 200 μm and ± 2000 μm (± .2000”, ± .0200” and ± .0020”).
 
Hello fernballan, That was an extreemely nice purchase. Do you have any data on the probe plug connections? This information seems almost impossible to get if one doesn't speak Swedish. I have just bought an older model 520 on eBay that seems to work fine but locating suitable probes is proving more difficult than I imagined. I would like to interface with a Mitutoyo lever probe. It should be possible.
 
Hello fernballan, That was an extreemely nice purchase. Do you have any data on the probe plug connections? This information seems almost impossible to get if one doesn't speak Swedish. I have just bought an older model 520 on eBay that seems to work fine but locating suitable probes is proving more difficult than I imagined. I would like to interface with a Mitutoyo lever probe. It should be possible.
Hi

You may excuse my English is not what it has been. There is a product catalog at this address.(Page 29 ) Or do you want to know if your prob is compatible with mentem. If you send a picture on your prob then I can call and ask here in Sweden
 
Back
Top