Angle cut

Does this make it clearer? I'm assuming you have a disc sander for your woodworking, so by dropping the table 30 degrees off 90 you could take half the width of one face off from two opposing sides of your 1/2 X 1/2 block and end up with a 120 degree ridge in the centre. Like this:

image.png

-frank
 
Does this make it clearer? I'm assuming you have a disc sander for your woodworking, so by dropping the table 30 degrees off 90 you could take half the width of one face off from two opposing sides of your 1/2 X 1/2 block and end up with a 120 degree ridge in the centre. Like this:

View attachment 277549

-frank
Before you replied here I got your idea but what I did was make a 30 degree wood wedge to use for the metal piece.
Now, with your drawing clearly stating what you meant, I am incredibly embarassed to say that yes, I do have that sander, yes, it does swivel with degree markings, and no, I didn’t even know that. Lol
 
Remember your sander markings probably aren't perfectly accurate. Better check the angles.
 
Back
Top