- Joined
- Mar 22, 2015
- Messages
- 3
I need a cylinder out of Delrin. I'll start with 150mm long x 93mm diameter stock and bore a 53mm hole leaving 20mm wall thickness. I'll leave one end solid to a depth of 20mm until the end.
My question: Am I going to run into trouble clamping the bored end (hollow cylinder end) in a 3-jaw chuck without distortion extending out to the face for my final face cut?
Thanks for any assistance. Trying to force some activity to learn to use the Shopmaster Patriot that's been sitting idle in my shop for close to 5 years now!
Stephan
My question: Am I going to run into trouble clamping the bored end (hollow cylinder end) in a 3-jaw chuck without distortion extending out to the face for my final face cut?
Thanks for any assistance. Trying to force some activity to learn to use the Shopmaster Patriot that's been sitting idle in my shop for close to 5 years now!
Stephan