carriage lock

  1. Ecosta777

    Homemade Clausing Micrometer Carriage Stop (Prints / Models)

    I recently got a Clausing 5914 12" lathe. It was unfortunately missing the micrometer carriage stop. I designed and have been working on a new one for it. Here are the photos of it in progress, I'm not quite done yet, but I will post finished photos when it's completed. Here is a link to the...
  2. H

    Modifying LMS 3536 Saddle

    I'm adding a carriage lock to the LMS 3536 from plans I found on You Tube (http://bit.ly/2nC8Zb7) The plans are for a 7x16 slightly smaller lathe. My saddle has a rib on the underside which makes locating the mounting block for the Lock a bit difficult. Would like to just mill off this rib...
Back
Top