clamping

  1. dhoodlum

    Sharing my clamp on scraper design

    Hi All, this is my first design for creating an anderson clamp on scraper. It's dimensioned to fit on a 1/8"x1"x18" thick steel plate to clamp a very large carbide insert, but it can be adapted to fit any size. Please tell me what you think! Just wanted to share because I could only find one...
  2. Swarfmaster

    V-block Clamp Clears The Drill Chuck

    I needed to drill a hole in a short 1/8 inch diameter rod. the clamp that I had was just too big to clear the drill chuck and the drill and still be able to get close to the rod. My clamp: Comparing the old with the new: The completed fixture with the new machining in place: There's plenty...
Back
Top