When I first bought my lathe, I've made this device afraid of letting the key in chuck.
As a side effect, it becomes very convenient when I finish a part I just grab the key (to remove part) and lathe stop.
My collets have been rough going up in the spindle . I looked up in there and the little R8 aligning grub screw is a little bit galled over. I'd like to remove this grub screw but can't figure out how. I removed the quill base but see no way to get at the grub screw. I called Matt earlier this...
Does anyone know how to cut a key slot in a shaft without using an end mill? Watched various youtube videos watching machinists work and on more than 3 sites, the machinists said not to cut a key slot in a shaft with an end mill because the end mill would either chip because it is hitting 2...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.