Steel (1018) mounting plate featuring two holes counter sunk to accommodate 10-32 bolts. These are the standard bolts for securing tool holders to the Sherline's cross slide.
The center is relived so that the clamping force of the nut securing the tool post is exerted over a smaller area there by increasing the pressure and by extension the holding force. This prevents the tool post from twisting under heavy cuts.
The center hole is threaded for the M10 stud that secures the tool post in place.
Mounting plate secured to the cross slide via two 10-32 bolts.
Mounting plate secured to cross slide via two 10-32 bolts. This also shows the M10 stud that the tool post is secured by.
0XA QCTP with holder mounted on the Sherline 4400 Lathe
The center is relived so that the clamping force of the nut securing the tool post is exerted over a smaller area there by increasing the pressure and by extension the holding force. This prevents the tool post from twisting under heavy cuts.
The center hole is threaded for the M10 stud that secures the tool post in place.
Mounting plate secured to the cross slide via two 10-32 bolts.
Mounting plate secured to cross slide via two 10-32 bolts. This also shows the M10 stud that the tool post is secured by.
0XA QCTP with holder mounted on the Sherline 4400 Lathe