- Joined
- Aug 25, 2018
- Messages
- 107
I have my new 1340 lathe setup and running off of the hitachi VFD using the stock contactors. I have the suggested joystick with 4-no switch blocks.
Using the below diagram, I’m not clear in if the #1 fwd and #2 rev outputs go into the contactors through the #4 and #5 terminals or directly to the inputs for #1 #2 p24/L on the contactors. Does the removed #3 jog switch wire need to be just removed? I can see that the #3 vfd input should go directly to the vfd input. And assuming the input from the E-switch on the stock switch #1? just gets taped and secured for continuity, I saw two other sets of joy stick instruction with various other options and just want to do it correctly without smoke. Thanks in-advance, the directions for the install are great and love the quality of the lathe. Still need to finish cleaning then leveling. Merry Christmas to me
Using the below diagram, I’m not clear in if the #1 fwd and #2 rev outputs go into the contactors through the #4 and #5 terminals or directly to the inputs for #1 #2 p24/L on the contactors. Does the removed #3 jog switch wire need to be just removed? I can see that the #3 vfd input should go directly to the vfd input. And assuming the input from the E-switch on the stock switch #1? just gets taped and secured for continuity, I saw two other sets of joy stick instruction with various other options and just want to do it correctly without smoke. Thanks in-advance, the directions for the install are great and love the quality of the lathe. Still need to finish cleaning then leveling. Merry Christmas to me