2 X 8 TPI Face plate and backing plates.

[kvt]

Looking for 2 inch by 8 TPI face plates and backing plates, Have found that there are a couple of different configurations on them. one fits the LAM style 10x24s and Jet 10X24P, then the spindle is diff on the Jet 10x24 PY. Some of the one for the older LAM and Jet 10X24 P will fit the newer 10X24 PY spindles but not all.

So looking for both types as one of each type and need some more backing plates and a FACE plate.

Any assistance greatly appreciated. KVTAYLOR At SBCGLOBAL dot net

 

[benmychree]

Why not make them? I made faceplates, that is large diameter and the smaller dog plate for my 9" Monarch lathe, I made patterns and had the cast in Iron and machined them, also made a steady and follow rest at the same time, from castings.