- Joined
- Dec 2, 2016
- Messages
- 234
So looking at the machine the left side screw is the adjustment and the right side is to remove?
I want to pull the table off and clean the oil galleys and flush the pumper lines. Also try to adjust some of the backlash.
Does anyone know the procedure to take off table?
Also I will post a picture but why have just an allen head set screw for a table stop on the X-Axis? Probably so its only used sparingly?
And does anyone have a drawing or picture of the spindle cap and know what the thread is? Mine seems to be missing and am not sure why I would even need one.
Thanks
First Cut (and second) sorry its not actually cutting. Table was jumping a lot trying to climb mill. Switched it around and feed was smooth.
I want to pull the table off and clean the oil galleys and flush the pumper lines. Also try to adjust some of the backlash.
Does anyone know the procedure to take off table?
Also I will post a picture but why have just an allen head set screw for a table stop on the X-Axis? Probably so its only used sparingly?
And does anyone have a drawing or picture of the spindle cap and know what the thread is? Mine seems to be missing and am not sure why I would even need one.
Thanks
First Cut (and second) sorry its not actually cutting. Table was jumping a lot trying to climb mill. Switched it around and feed was smooth.