Hallo all,
I have a 5 phase stepper motor PK596-AE from oriental stepper motors and planning to use a driver with built in controller (CRD514-KD). The motor has 10 lead wires and the drives has 5. I figured out that the motor (bipolar-pentagon)-driver connection should be as shown below.
Motor Driver
Blue + Black = Blue
Red + Brown = Red
Orange + Purple = Orange
Green + Yellow = Green
White + Grey = Black
the phase current of motor is 1.4A and driver can supply 2.8A.
1)Are they compatible or how can i limit the current to 1.4A? I have no idea about this!
2)All I wanted to do is to control the stepper motor remotely using switches (IN & OUT direction switches, Start switch with indicator as well as indicators for IN and OUT limits and ready to use indicator), all in one box. How can I implement this with CRD514-KD? I read in their operation manual that RS-485 communication is possible. But then there are options for 2 programmable controllers which I pretty don't understand.
3)Is it possible to drive 2 stepper motor-driver units synchronously?
Thanks.
I have a 5 phase stepper motor PK596-AE from oriental stepper motors and planning to use a driver with built in controller (CRD514-KD). The motor has 10 lead wires and the drives has 5. I figured out that the motor (bipolar-pentagon)-driver connection should be as shown below.
Motor Driver
Blue + Black = Blue
Red + Brown = Red
Orange + Purple = Orange
Green + Yellow = Green
White + Grey = Black
the phase current of motor is 1.4A and driver can supply 2.8A.
1)Are they compatible or how can i limit the current to 1.4A? I have no idea about this!
2)All I wanted to do is to control the stepper motor remotely using switches (IN & OUT direction switches, Start switch with indicator as well as indicators for IN and OUT limits and ready to use indicator), all in one box. How can I implement this with CRD514-KD? I read in their operation manual that RS-485 communication is possible. But then there are options for 2 programmable controllers which I pretty don't understand.
3)Is it possible to drive 2 stepper motor-driver units synchronously?
Thanks.