820 Logan Apron Question

[58APACHEE]

First off I'm new to the forum, looking forward to all the knowledge and experience on here that i can learn from.
-I recently purchased my first 820 Logan Lathe 200. I started rebuilding the Lathe (I Purchased the manual and parts catalog) and i go to the apron. I researched the different apron "configurations" for this model. I took my apron apart and i believe I'm missing some parts (see pics) but I'm not sure. can any of the experts advise?. the guy i bought from said it has never been taken apart. Thank You in advance.

 

[Bob Korves]

Well, I am not familiar with that lathe, but the half nuts are missing or not shown...

 

[58APACHEE]

that i did know which i should of mentioned, i ordered it already, thank you though for responding.

 

[tmenyc]

Looks like the clutch knob and shaft are missing too. What's your s/n?

 

[58APACHEE]

#27792
tmenyc thanks for the reply, I was looking for a picture but no luck.

 

[58APACHEE]

any P/N #'s would help too!.. thx in advance