Adapter needed!!!

[Wheresmywrench?]

I need to find an adater,95MM, for my V10-P, the chucks I have are 5.5 and 6 inch but are for DIN spindle. I have stadard 1 1/2-8 TPI Back plate. so I need an adapter to use the chucks I have. Any ideas as to where I might find one?? :talktogod: I don't want to buy a new chuck since the ones I have are EMCO.:makingdecision:

 

[davidh]

it may be good experience to make your own. . .
tools for your tools seem to be almost a necessity for us home shop guys.

 

[Wheresmywrench?]

Actually that's what I'm thinking. It looks like I'd just need to get a threaded blank(s) and cut the face so the chuck will fit.

 

[Wheresmywrench?]

I was also thinking about this adapter plate from Little Machine Shop.

http://www.littlemachineshop.com/products/product_view.php?ProductID=2347

 

[Smithdoor]

I just make my own for weights
Take and hour on the lathe, cost son left weight set after moving out now I have a hole set.

Dave

Actually that's what I'm thinking. It looks like I'd just need to get a threaded blank(s) and cut the face so the chuck will fit.

View attachment 87647

 

[Holescreek]

Anything here adaptable? http://www.grizzly.com/search?q=back plates&rankBy=&page=4&pageSize=24

 

[Wheresmywrench?]

If I get a threaded blank(s) with 1-1/2"X8 TPI I can turn it so it steps down in the middle then drill for the bolt holes then the chuck would fit.

 

[Holescreek]

The grizzly link went to page 2. Your blanks are on page 8. http://www.grizzly.com/products/6-X-1-1-2-8-TPI-Back-Plate/T10098

If that isn't the diameter you want just search "back plate" and scroll through the list.

 

[Smithdoor]

If you miss the holes just slot them If you miss the pilot ring just machining a little more off the backing plate
If live in Fresno/Clovis CA I would help you


Dave

If I get a threaded blank(s) with 1-1/2"X8 TPI I can turn it so it steps down in the middle then drill for the bolt holes then the chuck would fit.

 

[Wheresmywrench?]

OK found them. That's what I'm going to do. It makes the most sense to me. Thanks guys.