Another Milling table stop

[Janderso]

Made this out of scrap laying around.
This simple project allowed me to use the lathe, mill, surface grinder and hand tools.
I need to add some shorter studs to my table hardware and the stop needs one 1/4 20 set screw for the rod.
The odd size rod, .353” is from a HP printer.
Passes the time.
Happy Fathers Day to all.

 

[Ulma Doctor]

happy father's Day Jeff!
well done!

 

[benmychree]

Looking good! Maybe round over some of the corners?

 

[Janderso]

Looking good! Maybe round over some of the corners?

I agree, I was thinking of setting up the pieces in a V block and running the corners on the surface grinder.
Or, much easier, on the mill. For the corners and down the edges.

 

[benmychree]

Yes, sometimes we make a too quick of a move and take a piece of hide off our hand or arm; ouch! damn! -------

 

[benmychree]

I like a convolute fiberous wheel for easing edges and corners.

 

[Janderso]

I like a convolute fiberous wheel for easing edges and corners.

Convolute fiberous, I’ll check it out.

 

[benmychree]

They are like a grinding wheel, but fiberous, colored grey, made for deburring.

 

[hman]

Scotch-brite?

 

[benmychree]

No, much more dense.